CHAPTER 19 Coders and Profiles
Parameter
'Dial Plan Index'
dial-plan-index
[TelProfile_DialPlanIndex]
'Digital Cut Through'
digital-cut-through
[TelProfile_DigitalCutThrough]
'Call Priority Mode'
call-priority-mode
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■
Analog interfaces: If the parameter is enabled, it is
possible to configure the FXS/FXO interface to wait for
dial tone per destination phone number (before or during
dialing of destination phone number). Therefore, the
parameter IsWaitForDialTone (configurable for the
entire device) is ignored.
■
Analog interfaces: The FXS interface send SIP 200 OK
responses only after the DTMF dialing is complete.
■
The corresponding global parameter is
EnableDigitDelivery.
DialPlanIndex
Enables PSTN CAS channels/endpoints to receive
incoming IP calls even if the B-channels are in off-hook
state.
■
[0] Disable (default)
■
[1] Enable = When enabled, the feature operates as
follows:
a.
A Tel-to-IP call is established (connected) by the
device for a B-channel.
b.
The device receives a SIP BYE (i.e., IP side ends
the call) and plays a reorder tone to the PSTN side
for the duration configured by the
CutThroughTimeForReOrderTone parameter. The
device releases the call towards the IP side (sends
a SIP 200 OK).
c.
The PSTN side, for whatever reason, remains off-
hook.
d.
If a new IP call is received for this B-channel after
the reorder tone has ended, the device "cuts
through" the channel and connects the call imme-
diately (despite the B-channel being in physical off-
hook state) without playing a ring tone. If an IP call
is received while the reorder tone is played, the
device rejects the call.
Note:
■
If the parameter is disabled and the PSTN side remains
in off-hook state after the IP call ends the call, the
device releases the call after 60 seconds.
■
A special CAS table can be used to report call status
events (Active/Idle) to the PSTN side during Cut
Through mode (see
■
The corresponding global parameter is
DigitalCutThrough.
Defines call priority handling.
■
[0] Disable (default).
- 446 -
Configuring CAS State
Machines).