AudioCodes E-SBC User Manual page 1135

CHAPTER 68 Configuration Parameters Reference
Parameter
configure system > cli-
settings > telnet
[TelnetServerEnable]
'Telnet Server TCP Port'
configure system > cli-
settings > telnet-port
[TelnetServerPort]
'Telnet Server Idle Timeout'
configure system > cli-
settings > idle-timeout
[TelnetServerIdleDisconnect]
'Maximum Telnet Sessions'
configure system > cli-
settings > telnet-max-
sessions
[TelnetMaxSessions]
[CLIEnableModePassword]
'Default Terminal Window
Height'
configure system > cli-
settings > default-
window-height
[DefaultTerminalWindowHeight]
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■ [0] Disable
■ [1] Enable Unsecured (default)
■ [2] Enable Secured
Note: Only management users with Security Administrator
or Master user levels can access the CLI's Privileged
command mode.
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is
23.
Defines the duration of an idle CLI (Telnet or SSH) session
after which the session is automatically disconnected.
The valid range is any value. The default is 5. When
configured to 0, idle sessions are not disconnected.
Note: If you change the parameter's value when there are
current Telnet/SSH sessions, the parameter's previous
setting is still applied to these current sessions and the
parameter's new setting is applied only to new sessions.
Defines the maximum number of permitted, concurrent
Telnet or SSH sessions.
The valid range is 1 to 5 sessions. The default is 2.
Note: Before changing the value, make sure that not more
than this number of sessions are currently active;
otherwise, the new setting will not take effect.
Defines the password to access the Enable configuration
mode in the CLI.
The valid value is a string of up to 50 characters. The
default is "Admin".
Note: The password is case-sensitive.
Defines the number (height) of output lines displayed in the
CLI terminal window. This applies to all new CLI sessions
and is preserved after device resets.
The valid value range is -1 (default) and 0-65535:
■ A value of -1 means that the parameter is disabled and
the settings of the CLI command window-height is
used.
■ A value of 0 means that all the CLI output is displayed
in the window.
■ A value of 1 or greater displays that many output lines in
the window and if there is more output, the "—MORE—
" prompt is displayed. For example, if you configure the
parameter to 4, up to four output lines are displayed in
the window and if there is more output, the "—MORE—
" prompt is displayed (at which you can press the
spacebar to display the next four output lines).
- 1097 -