CHAPTER 65 Testing SIP Signaling Calls
●
Test Call Rules table configuration:
◆
◆
◆
◆
◆
◆
◆
Alternatively, if you want to route the test call using the Tel-to-IP Routing table for the Gateway
application, configure the following:
●
Test Call Rules table configuration:
◆
◆
◆
◆
◆
●
Tel-to-IP Routing table configuration:
◆
◆
◆
■
Batch Test Call Scenario: This example describes the configuration of a batch test call setup
for scheduled and continuous call testing of multiple endpoints. The test call is done between
two AudioCodes devices - Device A and Device B - with simulated test endpoints. This
eliminates the need for phone users, who would otherwise need to answer and end calls many
times for batch testing. The calls are initiated from Device A, where Device B serves as the
remote answering endpoint.
●
Test Call Rules table configuration at Device A:
◆
Endpoint URI: "101"
Called URI: "201"
Route By: Dest Address
Destination Address: "10.30.40.01"
SIP Interface: SIPInterface_0
Call Party: Caller
Test Mode: Once
Endpoint URI: 101@10.0.0.1
Route By: Tel-to-IP
SIP Interface: SIPInterface_0
Called URI: 201@10.30.40.1
Call Party: Caller
Destination Phone Prefix: 201 (i.e., the Called URI user-part)
Source Phone Prefix: 101 (i.e., the Endpoint URI user-part)
Destination IP Address: 10.30.40.1
Endpoint URI: "101"
Mediant 1000 Gateway & E-SBC | User's Manual
- 1081 -