Installing A License Key String - AudioCodes E-SBC User Manual

CHAPTER 45 License Key
Icon Color
Red
After you install the License Key (device reset with a save-to-flash), the icons no longer
appear and the License Key page displays only features and capacity of the new
License Key.

Installing a License Key String

You can install a License Key in encrypted string format, through the Web interface.
●
➢
To install a License Key string through Web interface:
1. Open the License Key page (see
2. Back up the currently installed License Key, as a precaution. If the new License Key does not
comply with your requirements, you can re-load this backed-up License Key to restore the
device's original capabilities. For backing up the License Key, see
Key.
3. Copy the License Key string (from the License Key file or e-mail) to your clipboard. Make sure
that you copy only the encrypted string (and not the serial number or any other part of the
string), as shown in the example below:
4. Click Load By String; the Load Feature Key By String dialog box appears.
5. In the text box, paste your License Key string, as shown in the following example:
Indicates features from the previous License Key that were not included in
the new License Key and are no longer available.
The License Key installation process includes a device reset and therefore, is
traffic-affecting. To minimize the disruption of current calls, it is recommended to
perform this procedure during periods of low traffic.
Viewing the License
Mediant 1000 Gateway & E-SBC | User's Manual
Description
Key).
- 873 -
Backing up the License