AudioCodes E-SBC User Manual page 1057

CHAPTER 57 Reporting Information to External Party
Parameter
'Title'
title
[GWCDRFormat_Title]
'RADIUS Attribute Type'
radius-type
[GWCDRFormat_
RadiusType]
'RADIUS Attribute ID'
radius-id
[GWCDRFormat_RadiusID]
Mediant 1000 Gateway & E-SBC | User's Manual
Defines a new name for the CDR field (for Syslog) or for the
RADIUS Attribute prefix name (for RADIUS accounting) that
you selected in the 'Column Type' parameter.
The valid value is a string of up to 31 characters.
You can configure the name to be enclosed by apostrophes
(single or double). For example, if you want the CDR field
name to appear as 'Phone Duration', you must configure the
parameter to 'Phone Duration'. You can also configure the
CDR field name with an equals (=) sign, for example "call-
connect-time=".
Note:
■ For RADIUS Attributes that do not require a prefix name,
leave the parameter undefined.
■ The parameter's value is case-sensitive. For example, if
you want the CDR field name to be Phone-Duration, you
must configure the parameter to "Phone-Duration" (i.e.,
upper case "P" and "D").
Defines whether the RADIUS Attribute of the CDR field is a
standard or vendor-specific attribute.
■ [0] Standard = (Default) For standard RADIUS Attributes.
■ [1] Vendor Specific = For vendor-specific RADIUS
Attributes (VSA).
Note: The parameter is applicable only for RADIUS
accounting (i.e., 'CDR Type' parameter configured to
RADIUS Gateway).
Defines an ID for the RADIUS Attribute. For vendor-specific
Attributes, this represents the VSA ID; for standard attributes,
this represents the Attribute ID (first byte of the Attribute).
The valid value is 0 to 255 (one byte). The default is 0.
Note:
■ The parameter is applicable only for RADIUS accounting
(i.e., 'CDR Type' parameter configured to RADIUS
Gateway).
■ For VSA's (i.e., 'RADIUS Attribute Type' parameter
configured to Vendor Specific), the parameter must be
configured to any value other than 0.
■ For standard RADIUS Attributes (i.e., 'RADIUS Attribute
Type' parameter configured to Standard), the value must
be a "known" RADIUS ID (per RFC for RADIUS).
However, if you configure the ID to 0 (default) for any of
the RADIUS Attributes (configured in the 'Column Type'
parameter) listed below and then apply your rule (Click
Apply), the device automatically replaces the value with
the RADIUS Attribute's ID according to the RFC:
✔
Destination Number: 30
✔
Source Number: 31
✔
Accounting Status Type: 40
- 1019 -
Description