AudioCodes E-SBC User Manual page 1168

CHAPTER 68 Configuration Parameters Reference
'REST CDR Report Level'
configure system > cdr
> rest-cdr-report-level
[RestCdrReportLevel]
'REST CDR HTTP Server
Name'
configure system > cdr
> rest-cdr-http-server
[RestCdrHttpServer]
'File Size'
configure troubleshoot
> cdr > file-size
[CDRLocalMaxFileSize]
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■ [4] Start & End & Update Media = Sends a CDR at
the start of the media, upon an update in the media (if
occurs), and at the end of the media.
Note:
■ The parameter is applicable only to the SBC
application.
■ To enable CDR generation as well as enable signaling-
related CDRs, use the CDRReportLevel parameter.
Enables signaling-related CDRs to be sent to a REST
server and defines the call stage at which they are sent.
■ [0] None = (Default) CDRs are not sent.
■ [1] End Call = CDRs are sent at the end (SIP BYE) of
each call.
■ [2] Start & End Call = CDRs are sent at the start (SIP
INVITE) and end of each call.
■ [3] Connect & End Call = CDRs are sent at call
connection (200 OK) and end of each call.
■ [4] Start & End & Connect Call = CDRs are sent at
the start, connection, and end of each call.
■ [5] Connect Only = CDRs are sent at call connection.
Note:
■ To specify the REST server, use the
[RestCdrHttpServer] parameter.
■ For the device to generate CDRs, you must enable
Syslog messaging (see the [EnableSyslog]
parameter).
■ CDRs are sent in JSON format.
Defines the REST server (by name as configured in the
Remote Web Services table) to where the device sends
CDRs through REST API.
The valid value is a string (i.e., name of the REST server).
By default, no value is defined.
Note:
■ The parameter value is case sensitive.
■ To enable CDR generation for the REST server, see
the [RestCdrReportLevel] parameter.
■ The REST server is configured in the Remote Web
Services table (see
on page 243).
Defines the size (in kilobytes) of each locally stored CDR
file. When the Current file reaches this size, the device
creates a CDR file containing all the CDRs from the
Current file.
The valid value is 100 to 10,000. The default is 1024.
- 1130 -
Configuring Remote Web Services