AudioCodes E-SBC User Manual page 1295

CHAPTER 68 Configuration Parameters Reference
[ResourcePriorityNetworkDomains]
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■ If the ISDN message contains a Precedence IE,
the device automatically interworks the "network
identity" digits in the IE to the network domain
subfield in the Resource-Priority header. For more
information, see Multilevel Precedence and
Preemption.
■ The parameter is applicable only to digital
interfaces.
Defines up to 32 user-defined MLPP network domain
names (namespaces). This value is used in the AS-
SIP Resource-Priority header of the outgoing SIP
INVITE request. The parameter is used in combination
with the MLPPDefaultNamespace parameter, where
you need to enter the table row index as its value.
The parameter is also used for mapping the Resource-
Priority field value of the SIP Resource-Priority header
to the ISDN Precedence Level IE. The mapping is
configured by the field, EnableIp2TelInterworking:
■ Disabled: The network-domain field in the
Resource-Priority header is set to "0 1 0 0" (i.e.,
"routine") in the Precedence Level field.
■ Enabled: The network-domain field in the
Resource-Priority header is set in the Precedence
Level field according to Table 5.3.2.12-4 (Mapping
of RPH r-priority Field to ISDN Precedence Level
Value).
The domain name can be a string of up to 10
characters.
The format of this table ini file parameter is as follows:
FORMAT ResourcePriorityNetworkDomains_Index =
ResourcePriorityNetworkDomains_Name,
ResourcePriorityNetworkDomains_
EnableIp2TelInterworking;
ResourcePriorityNetworkDomains 1 = dsn, 0;
ResourcePriorityNetworkDomains 2 = dod, 0;
ResourcePriorityNetworkDomains 3 = drsn, 0;
ResourcePriorityNetworkDomains 5 = uc, 1;
ResourcePriorityNetworkDomains 7 = cuc, 0;
[ \ResourcePriorityNetworkDomains ]
Note:
■ Indices 1, 2, 3, 5, and 7 cannot be modified and are
defined for DSN, DOD, DRSN, UC, and CUC,
respectively.
■ If the MLPPDefaultNamespace parameter is set to
-1, interworking from PSTN NI digits is done
automatically.
■ The parameter is applicable only to digital
interfaces.
- 1257 -