AudioCodes E-SBC User Manual page 1349

CHAPTER 68 Configuration Parameters Reference
configure voip > gateway
analog fxo-setting > fxo-
number-of-rings
[FXONumberOfRings]
'Dialing Mode'
configure voip > gateway
analog fxo-setting >
dialing-mode
[IsTwoStageDial]
'Waiting For Dial Tone'
configure voip > gateway
analog fxo-setting >
waiting-4-dial-tone
[IsWaitForDialTone]
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■ [1] = Enable. Port impedance is set to 800 Ohm for
1,500 msec to overcome the load. Overload
threshold is 160 mA. If you configure the
FXODCTermination parameter to 1, the threshold is
set to 60 mA.
Note: For the parameter to take effect, a device reset is
required.
Defines the number of rings before the device's FXO
interface answers a call by seizing the line.
The valid range is 0 to 10. The default is 0.
When set to 0, the FXO seizes the line after one ring.
When set to 1, the FXO seizes the line after two rings.
Note:
■ The parameter is applicable only if automatic dialing
is not used.
■ If caller ID is enabled and if the number of rings
defined by the parameter RingsBeforeCallerID is
greater than the number of rings defined by the
parameter, the greater value is used.
Global parameter defining the dialing mode for IP-to-Tel
(FXO) calls.
You can also configure the feature per specific calls,
using Tel Profiles (TelProfile_IsTwoStageDial). For a
detailed description of the parameter and for configuring
the feature in the Tel Profiles table, see
Profiles.
Note: If the feature is configured for a specific Tel
Profile, the settings of the global parameter is ignored for
calls associated with the Tel Profile.
Determines whether or not the device waits for a dial
tone before dialing the phone number for IP-to-Tel (FXO)
calls.
■ [0] No
■ [1] Yes (default)
When one-stage dialing and the parameter are enabled,
the device dials the phone number (to the PSTN/PBX
line) only after it detects a dial tone.
If the parameter is disabled, the device immediately
dials the phone number after seizing the PSTN/PBX line
without 'listening' for a dial tone.
Note:
■ The correct dial tone parameters must be configured
in the CPT file.
- 1311 -
Configuring Tel