AudioCodes E-SBC User Manual page 968

CHAPTER 50 System Status
Field
Call Establishment
Method
DTMF Selected
Method for Tx/Rx
Basic
Channel Identifier:
Status
Call ID
Endpoint ID
Call Duration
Call Type
Call Destination
Coder
Last Current Dis-
connect Duration
Line Current
Line Voltage
Hook
Ring
■ "Fax": Fax call
Mode of call:
■ "Normal": No early media during SIP session establishment (before
call accepted).
■ "EarlyMedia": Media sent (e.g., announcements) before call
accepted by called party.
DTMF Transport method used for the call. For configuring the transport
method, see Configuring DTMF Transport
Channel identifier number.
Status of port:
■ "Inactive": No call
■ "Active": Active call
See above.
ID of endpoint:
■ "Not Available"
Call duration (in seconds) from when call was established.
Type of call:
■ "Voice": Voice call
■ "Fax": Fax call
IP address of called party.
Coder type used for the call.
Duration of the disconnect signal.
Note: The parameter is applicable only to analog interfaces.
Line current (in mA).
Note: The parameter is applicable only to analog interfaces.
Line voltage (in V).
Note: The parameter is applicable only to analog interfaces.
Status of phone:
■ "0": On hook
■ "1": Off hook
Note: The parameter is applicable only to analog interfaces.
Status of ringing:
■ "0": Off
■ "1": On
Note: The parameter is applicable only to analog interfaces.
- 930 -
Mediant 1000 Gateway & E-SBC | User's Manual
Description
Types.