AudioCodes E-SBC User Manual page 1283

CHAPTER 68 Configuration Parameters Reference
'MWI Display'
configure voip > gateway
dtmf-supp-service supp-
service-settings >
enable-mwi
[MWIDisplay]
'Subscribe to MWI'
configure voip > gateway
dtmf-supp-service supp-
service-settings >
subscribe-to-mwi
[EnableMWISubscription]
'MWI Server IP Address'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
srvr-ip-addr
[MWIServerIP]
'MWI Server Transport Type'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
srvr-transp-type
[MWIServerTransportType]
'MWI Subscribe Expiration Time'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
subs-expr-time
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
■ If the feature is configured for a specific Tel Profile,
the settings of the global parameter is ignored for
calls associated with the Tel Profile.
■ The parameter is applicable only to FXS interfaces.
Global parameter enabling the sending of MWI
information to the phone display.
You can also configure the feature per specific calls,
using Tel Profiles (TelProfile_MWIDisplay). For a
detailed description of the parameter and for configuring
the feature in the Tel Profiles table, see
Profiles.
Note:
■ If the feature is configured for a specific Tel Profile,
the settings of the global parameter is ignored for
calls associated with the Tel Profile.
■ The parameter is applicable only to FXS interfaces.
Enables subscription to an MWI server.
■ [0] No (default)
■ [1] Yes
Note:
■ To configure the MWI server address, use the
MWIServerIP parameter.
■ To configure whether the device subscribes per
endpoint or per the entire device, use the parameter
SubscriptionMode.
Defines the MWI server's IP address. If provided, the
device subscribes to this IP address. The MWI server
address can be configured as a numerical IP address or
as a domain name. If not configured, the Proxy IP
address is used instead.
Determines the transport layer used for outgoing SIP
dialogs initiated by the device to the MWI server.
■ [-1] Not Configured (default)
■ [0] UDP
■ [1] TCP
■ [2] TLS
Note: When set to 'Not Configured', the value of the
parameter SIPTransportType is used.
Defines the MWI subscription expiration time in
seconds.
The default is 7200 seconds. The range is 10 to
2,000,000.
- 1245 -
Configuring Tel