AudioCodes E-SBC User Manual page 522

CHAPTER 20 SIP Definitions
Condition: ldap.found exists Action Type: Exit Action Value: True
■ Correct:
● Single rule:
Condition: ldap.found !exists Action Type: Exit Action Value: False
● Set of rules:
Condition: ldap.found exists Action Type: Exit Action Value: True
Condition: <leave it blank> Action Type: Exit Action Value: False
If the source and/or destination numbers are manipulated by the Call Setup rules, they
revert to their original values if the device moves to the next routing rule.
The following procedure describes how to configure Call Setup Rules through the Web interface.
You can also configure it through ini file [CallSetupRules] or CLI (configure voip > message
call-setup-rules).
➢
To configure a Call Setup rule:
1. Open the Call Setup Rules table (Setup menu > Signaling & Media tab > SIP Definitions
folder > Call Setup Rules).
2. Click New; the following dialog box appears:
3. Configure a Call Setup rule according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Parameter
General
'Index'
[CallSetupRules_
Index]
'Name'
rules-set-name
[CallSetupRules_
RulesSetName]
'Rules Set ID'
rules-set-id
[CallSetupRules_
RulesSetID]
Table 20-4: Call Setup Rules Parameter Descriptions
Defines an index number for the new table record.
Note: Each rule must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters.
Note: Each row must be configured with a unique name.
Defines a Set ID for the rule. You can define the same Set ID for
multiple rules to create a group of rules. You can configure up to 32 Set
IDs, where each Set ID can include up to 10 rules. The Set ID is used
to assign the Call Setup rules to a routing rule in the routing table.
The valid value is 0 to 31. The default is 0.
Mediant 1000 Gateway & E-SBC | User's Manual
Description
- 484 -