AudioCodes E-SBC User Manual page 1396

CHAPTER 68 Configuration Parameters Reference
'IPMedia Detectors'
configure voip > media
ipmedia > ipm-detectors-
enable
[EnableDSPIPMDetectors]
'Number of Media Channels'
configure voip > sbc
settings > media-channels
[MediaChannels]
IP-media-channels-enable
[EnableIPMediaChannels]
Table 68-66:IP Media Parameters
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
Enables the device's DSP detectors for detection
features such as AMD.
■ [0] Disable (default)
■ [1] Enable
Note:
■ For the parameter to take effect, a device reset is
required.
■ The DSP Detectors feature is available only if the
device is installed with a License Key that includes
this feature. For installing a License Key, see
License Key.
■ When enabled (1), the number of available
channels is reduced.
Defines the maximum number of DSP channels that
can be used for features requiring DSP resources, for
example, coder transcoding, DTMF transcoding, and
answer machine detection (AMD).
The default is -1, meaning the maximum DSP
channels, as defined by the License Key ("DSP
Channels").
Note:
■ Most SBC features that require DSP resources
use two DSP channels. For example, if the device
needs to perform coder transcoding between two
endpoints where one uses the G.711 coder and the
other uses G.729, and a maximum of 100
concurrent transcoding sessions need to be
supported, the device would use 200 DSP
channels. For this scenario, you would configure
the parameter to 200.
■ In some scenarios, the device may not have
sufficient DSP resources to process the number of
transcoding sessions as configured by the
MediaChannels parameter.
■ If you modify the parameter to a value that is less
than the number of DSP channels currently being
used by the device for currently active calls, the
device allows these calls to continue (and does not
terminate them).
■ The device can obtain additional DSP resources
for SBC functionalities requiring DSP resources
from PRI interfaces (if installed) and MPM modules
(if installed). For more information, see
Channel Resources for Transcoding
Enables IP media channel support.
■ [0] = Disable (default)
- 1358 -
DSP
on page 185.