Alcatel-Lucent 7750 SR Manual page 599

7750 SR OS Services Guide
— no
— priority
— no
— [no]
— ccm-ltm-priority
— no ccm-ltm-priority
— [no]
— test-pattern
— no
— fault-propagation-enable
— no fault-propagation-enable
— low-priority-defect
remErrXcon | errXcon | xcon | noXcon}
— mac-address
— no mac-address
— [no]
— [no] mip
— egress
— agg-rate-limit
— no agg-rate-limit
— filter ip ip-filter-id
— filter ipv6 ipv6-filter-id
— filter mac mac-filter-id
— no filter
— no filter [ip ip-filter-id] [mac mac-filter-id] [ipv6 ipv6-filter-id]
— [no] hsmda-queue-override
— packet-byte-offset
bytes}
— no packet-byte-offset
— queue
— no queue
— rate
— no
— slope-policy
— no
— secondary-shaper
— no secondary-shaper
— multicast-group
— no multicast-group
— [no] qinq-mark-top-only
— qos policy-id
— no qos
— [no] queue-override
— [no]
— adaptation-rule
adaptation-rule]
— no
— avg-frame-overhead
— no
— cbs
— no
— high-prio-only
— no
— mbs
Virtual Private LAN Services
interval
priority-value
priority
ccm-enable
priority
eth-test-enable
{all-zeros | all-ones} [crc-enable]
test-pattern
{use-if-tlv | suspend-ccm}
{allDef | macRemErrXcon |
mac-address
shutdown
agg-rate [queue-frame-based-accounting]
{add add-bytes | subtract sub-
queue-id [create]
queue-id
pir-rate [cir cir-rate]
rate
hsmda-slope-policy-name
slope-policy
secondary-shaper-name
group-name
queue queue-id
[pir adaptation-rule] [cir
adaptation-rule
percentage
avg-frame-overhead
size-in-kbytes
cbs
percent
high-prio-only
size-in-kbytes
Page 599