Alcatel-Lucent 7750 SR Manual page 753

Description This command configures the common SAP parameter requirements. The SAP common
requirements are used to evaluate each SAP for group membership. If a SAP does not meet the
specified requirements, the SAP is not allowed into the egress-multicast-group. Once a SAP is a
member of the group, attempting to change the parameters on the SAP will fail.
egress-filter
Syntax egress-filter [ip ip-filter-id]
egress-filter [ipv6 ipv6-filter-id]
egress-filter [mac mac-filter-id]
no egress-filter [ip ip-filter-id] [ipv6 ipv6-filter-id] [mac mac-filter-id]
Context config>service>egress-multicast-group>sap-common-requirements
Description
This command identifies the type of filter and actual filter ID that must be provisioned on the SAP
prior to the SAP being made a member of the egress-multicast-group. If the SAP does not have the
specified filter applied, the SAP cannot be provisioned into the group. It is important that the egress
filter applied to each SAP within the egress-multicast-group be the same since the batch replication
process on an efficient multicast replication chain will apply the first SAP's ACL decision to all other
SAPs on the chain. Once the SAP is made a member of the egress-multicast-group, the SAP's egress
filter cannot be changed on the SAP.
Changing the egress-filter parameters within the sap-common-requirements node automatically
changes the egress filter applied to each member SAP. If the filter cannot be changed on the SAP due
to resource constraints, the modification will fail.
The specified egress-filter does not contain an entry that is defined as an egress mirror-source. Once
the filter is associated with the egress-multicast-group, attempting to define one of its entries as an
egress mirror source will fail.
The no form of the command removes the egress-filter removes the egress filter from each member
SAP. The no egress-filter command specifies that an egress filter (IP, IPv6 or MAC) is not applied to
a new member SAP within the egress-multicast-group.
Default
Parameters
ip ip-filter-id — Specifies IP filter policy. The filter ID must already exist within the created IP
ipv6 ipv6-filter-id — Specifies the IPv6 filter policy. The filter ID must already exist within the
mac mac-filter-id — Specifies the MAC filter policy. The specified filter ID must already exist
7750 SR OS Services Guide
no filter. The egress filter ID must be defined with the associated ip or mac keyword. If an
egress-filter is not specified or the no egress-filter command is executed in the sap-common-
requirements node, a new member SAP does not have an egress IP or MAC filter defined.
filters.
Values
1 — 65535
created IPv6 filters.
Values 1 — 65535
within the created MAC filters. The filter policy must already exist within the created MAC
filters.
Values
1 — 65535
Virtual Private LAN Services
Page 753