Alcatel-Lucent 7750 SR Manual page 735

Default maximum number of attributes
Parameters value — Specifies the number of attributes accepted on a per BVPLS basis.
attribute-table-high-wmark
Syntax [no] attribute-table-high-wmark high-water-mark
Context config>service>vpls>mrp
Description This command specifies the percentage filling level of the MMRP attribute table where logs and traps
are sent.
Default
95%
Parameters high-water-mark — 1%-100%
attribute-table-low-wmark
Syntax [no] attribute-table-low-wmark low-water-mark
Context config>service>vpls>mrp
Description
This command specifies the MMRP attribute table low matermark as a percentage. When the
percentage filling level of the MMRP attribute table drops below the configured value, the
corresponding trap is cleared and/or a log entry is added.
Default
90%
Parameters low-water-mark — 1%-100%
flood-time
Syntax flood-time flood-time
no flood-time
Context config>service>vpls>mrp
Description This command configures the amount of time, in seconds, after a status change in the VPLS service
during which traffic is flooded. Once that time expires, traffic will be delivered according to the
MMRP registrations that exist in the VPLS.
Default
3 seconds
Parameters
flood-time — Specifies the MRP flood time, in seconds.
7750 SR OS Services Guide
Values
SR-7/SR-12:
SR-1
Values
3 — 600
1 — 2047
1 — 1023
Virtual Private LAN Services
Page 735