Alcatel-Lucent 7750 SR Manual page 630

Virtual Private LAN Services
active secondary pseudowire fails and is restored it will stay in standby until a configuration change
or a force command occurs.
Parameters
revert-time — Specifies the time to wait, in seconds, before reverting back to the primary spoke SDP
infinite — Specifying this keywork makes endpoint non-revertive.
static-mac
Syntax static-mac ieee-address [create]
no static-mac
Context config>service>vpls>endpoint
Description
This command assigns a static MAC address to the endpoint. In the FDB, the static MAC is then
associated with the active spoke SDP.
Default
none
Parameters
ieee-address — Specifies the static MAC address to the endpoint.
create — This keyword is mandatory while creating a static MAC.
suppress-standby-signaling
Syntax [no] suppress-standby-signaling
Context config>service>vpls>endpoint
Description
When this command is enabled, the pseudowire standby bit (value 0x00000020) will not be sent to T-
LDP peer when the given spoke is selected as a standby. This allows faster switchover as the traffic
will be sent over this SDP and discarded at the blocking side of the connection. This is particularly
applicable to multicast traffic.
Default
enabled
propagate-mac-flush
Syntax [no] propagate-mac-flush
Context config>service>vpls
Description This command enabled propagation of mac-flush messages received from the given T-LDP on all
spoke and mesh-sdps within the context of the VPLS service. The propagation will follow split-
horizon principles and any data-path blocking in order to avoid looping of these messages.
Page 630
defined on this service endpoint, after having failed over to a backup spoke SDP.
Values
0 — 600
Values 6-byte mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx). Cannot be all zeros.
7750 SR OS Services Guide