Alcatel-Lucent 7750 SR Manual page 685

managed-vlan-list
Syntax managed-vlan-list
Context config>service>vpls>sap
Description This command enables the context to configure VLAN ranges to be managed by a management
VPLS. The list indicates, for each SAP, the ranges of associated VLANs that will be affected when
the SAP changes state. This managed-vlan-list is not used when STP mode is MSTP in which case the
vlan-range is taken from the config>service>vpls>stp>msti configuration.
This command is only valid when the VPLS in which it is entered was created as a management
VPLS.
default-sap
Syntax [no] default-sap
Context config>service>vpls>sap>managed-vlan-list
Description This command adds a default SAP to the managed VLAN list.
The no form of the command removes the default SAP to the managed VLAN list.
range
Syntax [no] range vlan-range
Context config>service>vpls>sap>managed-vlan-list
Description
This command configures a range of VLANs on an access port that are to be managed by an existing
management VPLS.
This command is only valid when the VPLS in which it is entered was created as a management
VPLS, and when the SAP in which it was entered was created on an Ethernet port with encapsulation
type of dot1q or qinq, or on a Sonet/SDH port with encapsulation type of bcp-dot1q.
To modify the range of VLANs, first the new range should be entered and afterwards the old range
removed. See
Default
None
Parameters
vlan-range — Specify the VLAN start value and VLAN end value. The end-vlan must be greater than
7750 SR OS Services Guide
Modifying VPLS Service Parameters on page
start-vlan. The format is <start-vlan>-<end-vlan>
Values
start-vlan: 0 — 4094
end-vlan: 0 — 4094
Virtual Private LAN Services
586.
Page 685