Is A Clicking Sound No - Mahindra XUV 500 Diagnostic Manual

DIAGNOSTIC MANUAL
NO
STEP 2
Ignition OFF
Ensure the main relay is fixed
properly in the connector of the
engine compartment fuse box
Remove the main relay
Check the functioning of relay by
providing 12V to terminal 85
and ground to terminal 86
STEP 3
Ignition OFF
Remove the main relay
Check the voltage between pin
85 of the main relay seating on
BEC and battery ground
Check the voltage between pin
pin 30 of the main relay seating
on BEC and battery ground
Go to STEP 4
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2011 Mahindra & Mahindra Ltd.
EMS
Connect the smart tester
Turn the ignition ON
Initialise the diagnostic tool
Is EMS ECU
communicates with
the tool?
YES Is a clicking sound
YES Is the value =Vbat?
STEP 1
heard?
MAN-00152
OCT 2011/Rev 1
YES
Intermittent problem exists
Refer the intermittent problem
inspection procedure
NO
Replace the main relay with a
new one
Clear the DTC and verify
NO
Ensure the 150 A main fuse
(MF2) is functioning properly
Ensure the battery to BEC
connections are intact
Replace the BEC with a new one
Clear the DTC and verify
300