Mahindra XUV 500 Diagnostic Manual page 97

DIAGNOSTIC MANUAL
STEP 2
Ignition OFF
Camphase sensor wiring
harness connector
DISCONNECTED
Check for proper fitment of the
cam phase sensor mounting bolt
STEP 3
Ignition OFF
Camphase sensor wiring
harness connector
DISCONNECTED
Remove the cam phase sensor
Check for any damage on the
cam phase sensor front face
STEP 4
Check the cam shaft end play
Suspect cam phase sensor
internal failure
Replace cam phase sensor with
a with a new one.
Check and verify for any new
DTC's
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2011 Mahindra & Mahindra Ltd.
EMS
STEP 1
Connect the smart tester
Turn the ignition ON
Initialise the diagnostic tool
Record the DTC and clear
Turn ignition OFF
Turn ignition ON
Crank the engine
Verify if P0341 is present?
YES Is P0341 present?
NO Is the bolt fitted
properly?
Is there any
NO
damage?
YES Is the end paly with
in limits?
MAN-00152
OCT 2011/Rev 1
NO
Intermittent problem exists
Refer the intermittent problem
inspection procedure
YES
Fix the bolt properly and tighten
it to the torque specified
Clear the DTC and verify
YES
Suspect for any foreign particles
presence.
Identify the cause and rectify
Replace the cam phase sensor
with a new one
Clear the DTC and verify
NO
Identify the root cause of the
cam shaft end play and rectify
Clear the DTC and verify
96