Download Print this page

Mahindra XUV 500 Diagnostic Manual page 312

Hide thumbs Also See for XUV 500:

Advertisement

DIAGNOSTIC MANUAL
YES
STEP 2
Ignition OFF
Clutch sensor wiring harness
connector DISCONNECTED
Ignition ON
Check the voltage between pin
4 of the clutch sensor wiring
harness connector and battery
ground
STEP 3
Ignition OFF
EMS ECU wiring harness
connector DISCONNECTED
Clutch sensor wiring harness
connector DISCONNECTED
Check the resistance between
pin 1 of the clutch sensor wiring
harness connector and pin 23 of
the EMS ECU wiring harness
connector
Check the resistance between
pin 2 of the clutch sensor wiring
harness connector and pin 41 of
the EMS ECU wiring harness
connector
Go to STEP 4
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2011 Mahindra & Mahindra Ltd.
Connect the smart tester
Turn the ignition ON
Initialise the diagnostic tool
Record the DTC and clear
Turn ignition OFF
Turn ignition ON
Verify if P0704 is present?
Is P0704 present?
YES
Is the value =5 ±0.25
YES
Is the value < 1Ω?
EMS
STEP 1
V?
MAN-00152
OCT 2011/Rev 1
NO
Intermittent problem exists
Refer the intermittent problem
inspection procedure
NO
Examine the open /short circuit
in clutch sensor power supply
wire
Repair/replace the wiring
harness
Clear the DTC and verify
If the DTC still exists suspect
EMS ECU.
Replace the EMS ECU with a
new one
NO
Examine the open circuit in
clutch sensor signal wires to
EMS ECU
Repair/replace the wiring
harness
Clear the DTC and verify
311

Hide quick links:

Advertisement

loading