Mahindra XUV 500 Diagnostic Manual page 99

DIAGNOSTIC MANUAL
STEP 2
Check the flywheel mounting
bolts for tightness
Check the cam shaft/crankshaft
mounting bolts for tightness
STEP 3
Check for any damage on the
trigger wheel teeth
Check for proper mounting of
trigger wheel mounting screws
STEP 4
Check the sprockets and chain
for any damage
Check for proper functioning of
hydraulic chain tensioner
If not functioining properly ,
replace with a new one
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2011 Mahindra & Mahindra Ltd.
EMS
Connect the smart tester
Turn the ignition ON
Initialise the diagnostic tool
Record the DTC and clear
Turn ignition OFF
Turn ignition ON
Crank the engine
Verify if P1341 is present?
YES Is P1341 present?
NO Are the bolts tight?
Is there any
NO damage/screws
loosened?
YES Is there any
damage ?
STEP 1
MAN-00152
OCT 2011/Rev 1
NO
Intermittent problem exists
Refer the intermittent problem
inspection procedure
YES
Tighten the bolts to the torque
specified
Clear the DTC and verify
YES
If the screws are loosened ,
tighten to torque
If toner wheel damaged, replace
it with a new one
Clear the DTC and verify
NO
Replace the chain/sprocket
assembly with a new one
Clear the DTC and verify
98