Mahindra XUV 500 Diagnostic Manual page 104

DIAGNOSTIC MANUAL
STEP 6
Check for any damage on the
trigger wheel teeth
Check for proper mounting of
trigger wheel mounting screw
STEP 7
Check whether the crankshaft
speed sensor wire routing is
closer to starter motor
Suspect crankshaft speed
sensor internal failure
Replace crankshaft speed sensor
with a with a new one.
Check and verify for any new
DTC's
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2011 Mahindra & Mahindra Ltd.
Check the crankshaft end play
YES Is the end paly with
NO damage/screws
NO Is the wire closer to
starter motor?
EMS
STEP 5
in limits?
Is there any
loosened?
MAN-00152
OCT 2011/Rev 1
NO
Identify the root cause of the
crank shaft end play and rectify
Clear the DTC and verify
YES
If the screws are loosened ,
tighten to torque
If toner wheel damaged, replace
it with a new one
Clear the DTC and verify
YES
Route the wires correctly
(Refer wiring manual for proper
routing)
Clear the DTC and verify
103