Mahindra XUV 500 Diagnostic Manual page 93

DIAGNOSTIC MANUAL
STEP 6
Ignition OFF
Camphase sensor wiring
harness connector
DISCONNECTED
EMS ECU wiring harness
connector DISCONNECTED
Check the resistance between
between pin 2 of the cam
phase sensor wiring harness
connector and pin 46 of the EMS
ECU wiring harness connector
Check the resistance between
between pin 1of the cam phase
sensor wiring harness
connector and pin 44 of the EMS
ECU wiring harness connector
Suspect cam phase sensor
internal failure
Replace cam phase sensor with
a with a new one.
Check and verify for any new
DTC's
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present document,
are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd.,
will amount to unauthorized use and shall be liable for penalty/prosecution© 2011 Mahindra & Mahindra Ltd.
EMS
Ignition OFF
Camphase sensor wiring
harness connector
DISCONNECTED
Check the resistance between
between pin 2 of the cam
phase sensor wiring harness
connector and ground
YES Is the value < 1Ω?
YES Is the value < 1Ω?
STEP 5
MAN-00152
OCT 2011/Rev 1
NO
Examine the short circuit of
cam phase sensor signal wire
to ground
Repair/replace the wiring
harness
Clear the DTC and verify
NO
Examine the open circuit of
cam phase sensor ground and/
or signal wire
Repair/replace the wiring
harness
Clear the DTC and verify
92