Ricoh AP-P2 G188 Field Service Manual page 92

2. Installation
2
6. Pull out tray 2 from the mainframe.
7. Replace the shoulder screw [E] with the washer screw [F], using the securing bracket [G] ( x 1).
8. Connect the harness [H] to the connector [I] of the tray heater.
9. Route the harness [H] as shown and clamp it with four clamps (
• Make sure that the harness [H] is placed below the harness [J].
10. Connect one harness [K] of the two-way harness to the connector [L] of the mainframe.
• Connect [K] to the connector on the mainframe. The harness of connector [K] has two binders.
The harness of the other connector [M] has one binder, and this is for another optional paper
feed unit.
11. Clamp the other harness [M] of the two-way harness as shown [N] if you do not install another optional
paper feed unit.
90
x 4).