Ricoh AP-P2 G188 Field Service Manual page 439

0 None
1: Vertical Line (1dot)
2: Vertical Line (2dot)
3: Horizontal (1dot)
4: Horizontal (2dot)
5: Grid Vertical Line
6: Grid Horizontal Line
7: Grid pattern Small
8: Grid pattern Large
9: Argyle Pattern Small
10: Argyle Pattern Large
005 Color Selection
006 Density: Bk
007 Density: M
008 Density: C
009 Density: Y
2111 [Forced Line Position Adj.]
001 Mode a
002 Mode b
003 Mode c
11. Independent Pattern (1dot)
12. Independent Pattern (2dot)
13. Independent Pattern (4dot)
14. Trimming Area
16: Hound's Tooth Check (Horizontal)
17: Band (Horizontal)
18: Band (Vertical)
19: Checker Flag Pattern
20: Grayscale Vertical Margin
21: Grayscale Horizontal Margin
23: Full Dot Pattern
Specifies the color for the test pattern.
- [1 to 4 / 1 / 1/step]
1: All colors, 2: Magenta, 3: Yellow, 4: Cyan
-
Specifies the color density for the test pattern.
-
[0 to 15 / 15 / 1 /step]
0: Lightest density
-
15: Darkest density
-
Executes the fine line position adjustment twice.
-
If this SP is not completed (NG is displayed), do
SP2111-003 first and then try this SP again.
Executes the fine line position adjustment once.
-
If this SP is not completed, do SP2111-003 first and
then try this SP again.
Executes the rough line position adjustment once.
After doing this SP, make sure to execute
-
SP2111-001 or -002. Otherwise, the line position
adjustment is not perfectly done.
Engine Service Mode
8
181