Ricoh AP-P2 G188 Field Service Manual page 149

1. K PCU (* p.123)
2. Fusing unit (* p.173)
3. Image transfer belt unit (* p.134)
4. Slide the ID sensor shutter [A] to the left side.
5. Clean the ID sensors keeping the ID sensor shutter to the left.
After installing a new ID sensor unit/board
Do the following adjustment after installing a new ID sensor unit/board.
1. Plug in and turn on the main power switch of the mainframe.
2. Enter the SP mode.
3. Input all correction coefficients [A] for the ID sensor with the SP modes referring to the barcode sheet
provided with the new ID sensor unit/board.
• For example, input "1.00" with SP3-362-013.
4. Exit the SP mode.
Paper Transfer
4
147