Ricoh AP-P2 G188 Field Service Manual page 519

3043 [TD Adjust Mode]
Rept Numbr: Power ON
Specifies the maximum number of repeats of the toner density adjustment at power on.
0: Disabled, 1 to 3: Repeat number,
001
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Rept Numr: Initialization
Specifies the maximum number of repeats of the toner density adjustment at the developer
initialization.
0: Disabled, 1 to 3: Repeat number,
002
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Rept Numr: Non-use
Specifies the maximum number of repeats of the toner density adjustment in stand by mode.
0: Disabled, 1 to 3: Repeat number,
003
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
Rept Numr: ACC
Specifies the maximum number of repeats of the toner density adjustment at ACC.
0: Disabled, 1 to 3: Repeat number,
004
4: Repeat three times (No consumption mode)
5: Repeat three times (Toner is supplied only when the toner density is too low, and toner is
consumed only when the toner density is too dark.)
6 to 9: Disabled
*ENG [0 to 9 / 4 / 1 time/step]
*ENG [0 to 9 / 3 / 1 time/step]
*ENG [0 to 9 / 0 / 1 time/step]
*ENG [0 to 9 / 3 / 1 time/step]
Engine Service Mode
8
261