Ricoh AP-P2 G188 Field Service Manual page 180

4. Replacement and Adjustment
• The surface of the heating roller is fragile, so the heating roller must be covered with a sheet of
paper when it is placed on a table or floor.
When re-installing the heating roller
4
1. Apply three spots of "Barrierta S552R" (the diameter of each spot must be about 3 mm in diameter,
and approximately 0.1 g in weight) to the front shaft of the heating roller at 2 - 3 mm from the notch
[A].
2. Apply three spots of "Barrierta S552R" (the diameter of each spot must be about 3 mm in diameter,
and approximately 0.1 g in weight) to the rear shaft of the heating roller at 2 - 3 mm from the edge
[B] (rear side of the heating roller).
• Do not wipe off the grease of the new idle gear when replacing the idle gear [A]. (The actual
idle gear [A] is white.)
178