Ricoh AP-P2 G188 Field Service Manual page 429

SP2-XXX (Drum)
[Charge DC Voltage] Charge Roller DC Voltage Adjustment
(Paper Type, Process Speed, Color)
2005 Paper Type –> Plain, Thick 1, Thick 2
Plain: 205 (P2c)/ 230 (P2d) mm/sec, Thick 1: 154 mm/sec,
Thick 2&FINE: 77 mm/sec
Adjusts the DC component of the charge roller bias in the various print modes.
Charge bias (DC component) is automatically adjusted during process control; therefore,
adjusting these settings does not effect while process control mode (SP3-041-1 Default: ON)
is activated. When deactivating process control mode with SP3-041-1, the values in these
SP modes are used for printing.
001 Plain: Bk
002 Plain: M
003 Plain: C
004 Plain: Y
005 Thick 1: Bk
006 Thick 1: M
007 Thick 1: C
008 Thick 1: Y
009 Thick 2&FINE: Bk
010 Thick 2&FINE: M
011 Thick 2&FINE: C
012 Thick 2&FINE: Y
013 Plain
014 Thick 1
015 Thick 2&FINE
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
[0 to 1000 / 690 / 10 –V/step]
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
[–100 to 100 / P2c: –23, P2d: –16 / 1 –V/
*ENG
step]
*ENG [–100 to 100 / –24 / 1 –V/step]
*ENG [–100 to 100 / 2 / 1 –V/step]
Engine Service Mode
8
171