Ricoh AP-P2 G188 Field Service Manual page 416

8. Appendix: SP Mode Tables
Interval
001
Specifies the interval between idling during stand-by mode.
This idling during the stand-by mode prevents the roller deformation.
Idling Time
002
Specifies the length of each idling operation during stand-by mode.
1117 [Idling Time After Heater OFF]
Time After Heater OFF
002
Specifies the idling time without the lamp on after job end.
This idling prevents the heating roller overheating after job end.
1118 [Curl Temperature Correction]
ON/OFF
001
Enables or disables the curl correction mode.
002 Humidity 1
8
003 Humidity 2
1120 [Continues Print Mode Switch]
Paper Feed Condition
001
Selects the paper feed timing.
0: Productivity priority, 2: Fusing quality priory
1121 [Idling Time After Job]
001 Discontinues Job
002 Job End: Min
003 Job End: Max
1122 [Repeat Print temp. Correction] DFU
158
*ENG [1 to 240 / 60 / 1 min/step]
*ENG [0 to 60 / 0.7 / 0.1 sec/step]
*ENG [0 to 20 / 0 / 1 sec/step]
[0 or 1 / 0 / 1]
*ENG
0: OFF, 1: ON
*ENG [0 to 100 / 60 / 1 %]
*ENG [0 to 100 / 80 / 1 %]
*ENG [0 or 2 / 0 / 1]
*ENG [0 to 200 / 15 / 1 sec/step]
*ENG [0 to 200 / 5 / 1 sec/step]
*ENG [0 to 200 / 15 / 1 sec/step]