Function Description Of Mode Selector S11 - Jetter JC-120MC User Manual

4 Mechanical and electrical installation

Function description of mode selector S11

Mode selector S11
Functions of the mode
selector
64
RUN
STOP
Position
RUN
The controller launches the application program.
STOP
The controller does not launch the application program.
LOAD The controller executes the file autocopy.ini which is located
on the SD card.
The JC-120MC checks the position of selector S11 in the following way:
Step
1 Power supply of the controller is at terminal X10.
2 The boot loader of the controller checks the position of selector S11.
... mode selector S11 = RUN or
STOP, ...
... selector S11 = LOAD position,
and an SD card has been inserted.
... selector S11 = LOAD position,
and an SD card has not been
inserted.
3 The controller loads the fileautocopy.ini.
... the file could be loaded, ...
... the file could not be loaded, ...
4
The controller checks the position of selector S11.
... mode selector S11 = RUN, ...
... mode selector S11 = STOP, ...
S11
LOAD
X14
Behavior after power-up
Description
If ...
... the OS is launched;
--> proceed with step 4.
... the OS is launched;
--> proceed with step 3.
... the boot loader waits until an OS
update is carried out
If ...
... the instructions contained in it are
executed.
... proceed with step 4.
If ...
... the application program is
launched.
... the application program does not
start.
... then ...
... then ...
... then ...
Jetter AG