E-Mail - Jetter JC-120MC User Manual

JC-120MC
10.13

E-mail

Introduction
Activating the E-mail
feature
Required programmer's
skills
Contents
Jetter AG
The user creates template files for e-mails. Into these templates, the controller
JC-120MC can enter variables for sending, if required. The controller sends
e-mails to an e-mail server which will then forward the message.
This chapter gives a description on how to configure the e-mail feature in the
JC-120MC, and on how to create and send e-mails.
To activate the e-mail feature in the JC-120MC, the following requirements
must be met:
 When ordering the controller option -W was selected.
 A valid e-mail configuration file /EMAIL/email.ini exists while the controller
is booting.
If both requirements have been met, the corresponding bit in the web status
register is set.
To be able to use the e-mail feature, the following skills are required:
Since files are used to configure the e-mail feature, and e-mails as such

are based on these files, the user must be familiar with the file system.
IP networks

Topic
Configuring the E-mail feature .................................................................... 424
Creating e-mails.......................................................................................... 432
Sending an e-mail ....................................................................................... 441
Registers ..................................................................................................... 442
Programming
Page
423