The Application Program Is Stored To The Sd Card - Jetter JC-120MC User Manual

JC-120MC

The application program is stored to the SD card

Introduction
Prerequisites
Storing the application
program to the SD card
/app/start.ini - Structure
Related topics
Jetter AG
When uploading the application program from JetSym to the controller, the
default storage for application programs is used.
If you want the device to read the application program from the SD card, you
have to configure the file path.
If you want to store the application program to another directory of the internal
flash disk, proceed the same way.
Since the controller's file system is case sensitive, make sure that path and file
names, as well as file entries are spelled correctly.
To store the application program to the SD card, configure the device as
follows:
Step
1
Create an application program file by JetSym.
2
Create the desired directory on the SD card.
3
Store the application program file to the desired directory.
4
Enter the path to the application program file and the program name into
the file /app/start.ini on the internal flash disk of the device.
Result: On re-boot, the device loads the application program from the
SD card.
This file is a text file with one section holding two entries:
Element
[Startup]
Project
Program
Example:
[Startup]
Project = /SD/TestProgram
Program = Test1.es3
Result:The application program is loaded from the file Test1.es3 located in
the folder TestProgram on the SD card (/SD/TestProgram/Test1.es3).
 Application program - Default path (see page 600)
Action
Description
Section name
Path leading to the application program file
Name of the application program file
Application program
601