Table of Contents
Advertisement
JC-120MC
Device numbers
Introduction
Device numbers
MR 2824
Jetter AG
The device number lets you define the HMI.
You may enter the following values for the parameter Device number:
Number
Element
0
Default device
1
HMI # 1
2
HMI # 2
3
HMI # 3
4
HMI # 4
5 ... 7
Reserved
8
Printer module
9, 10
Serial interface
11
Serial interface module
Device number of the default device
This module register contains the device number of the default device. If you
always specify the default device in the application program (device number =
0), you can select during runtime which device is actually to be used.
Module register properties
Values
1 ... 11
Value after reset
2
Description
MR 2824 holds the number of the device to
be used.
Multi-display mode
Single-/Multi-display mode
Multi-display mode
Multi-display mode
Do not use
Output of data on a printer module connected
to the JX2 or JX3 system bus
Output of data on a user-programmable serial
interface
Output of data on a serial interface module
connected to the JX2 or JX3 system bus
Programming
385
Advertisement
Table of Contents
