Jetter JC-120MC User Manual page 226

10 Programming
Client
Server
Protocols
Contents
226
Below, programming the client in the controllers is described. In doing so, the
following topics are dealt with:
 Transferring variable/register sets (command group NetCopy())
 Setting and clearing register bits (command group NetBit())
 Transmitting individual register values (network registers)
Examples of the application
Event-triggered data interchange

Parameterization

Configuration

Used protocol
The client of the controller uses the JetIP protocol based on UDP/IP for data
transfer.
The server functions do not require any programming or configuration by the
user.
Acyclic data interchange on the Jetter system bus can be established by the
following protocols:
 XCOM protocol by Jetter AG
 JetIP protocol by Jetter AG
 UDP/IP
 TCP/IP
 IPv4
Topic
Command group NetCopy() ........................................................................ 227
Command group NetBit() ............................................................................ 229
Network registers ........................................................................................ 230
Registers located on JX3 modules ............................................................. 232
Indirect addressing of remote modules ....................................................... 234
Addressing with variable destination window ............................................. 236
Register description - Acyclic data interchange .......................................... 238
Page
Jetter AG