Assigning Names To Keys/Locks - Jetter JC-120MC User Manual

6 File system

Assigning names to keys/locks

Introduction
Configuring names
Structure of the
configuration file
Section
146
Keys/locks are consecutively numbered from 1 through 31. To provide ease of
handling, a name can be assigned to each key/lock combination. These
names are assigned in the configuration file /System/keys.ini.
To assign names to keys/locks, proceed as follows:
Step
1
Establish an FTP connection to the device; when doing so, log in with
administrator rights.
2 Open the file /System/keys.ini.
3
Adjust the file entries.
4
Save the changed file to the device.
5
Reboot the device.
Result:
The names are available now. The names are now available and can be used
when assigning locks and managing user accounts.
This configuration file is a text file containing one section.
 In this section values can be set which are then used by the file system.
 Each key is specified with its name in an individual line.
 You can insert blank lines as required.
 The following characters precede a comment line: "!", "#" or ";".
The section is named [KEYS]. Here, names are assigned to keys/locks in
accordance with the following rule:
KEYxx=Name
xx: Number of the key (01 ... 31)
Example:
[KEYS]
KEY01=Admin
KEY02=System
KEY03=
KEY04=
KEY05=service
...
KEY31=
Action
Jetter AG