Fasteneing The Ktp Mobile Wall-Mounting Bracket - Siemens SIMATIC HMI TP1000F Mobile RO Operating Instructions Manual

Installing system components
3.4 Attaching the KTP Mobile wall-mounting bracket
3.4.3

Fasteneing the KTP Mobile wall-mounting bracket

Requirement
The requirements refer to the installation of the wall-mounting bracket to a control cabinet.
● A level bolting surface
● 3 M5 bolts and a suitable screwdriver
● 3 M5 nuts and a suitable wrench
Procedure
1.
2.
3.
4.
See also
KTP Mobile wall-mounting bracket dimension drawing (Page 164)
42
Place the wall-mounting bracket level
on the mounting surface.
Mark the drill holes at the indicated
locations in the figure on the right.
Drill 3 holes for M5 type bolts based on
your mounting requirements.
Fasten the wall-mounting bracket with
the bolts and nuts.
Operating Instructions, 08/2017, A5E39831415-AA
TP1000F Mobile RO