Table of Contents
Advertisement
5.13.4
Updating the HMI device image (ProSave)
The following applications are pre-installed on the HMI device:
● The Microsoft Windows Embedded Compact 2013 operating system.
● The RemoteOperate Client software
The "SIMATIC RemoteOperate - Applications & Documentation" CD contains:
● The HMI device image file with the operating system and the RemoteOperate Client
software
● The ProSave software
● The ProSave add-on with the information for the HMI device.
When you update the operating system on the HMI device or want to reset the HMI device to
factory settings, you have the transfer the image once again to the HMI device. To do this,
connect a PC to the HMI device and then start to transfer the image using ProSave.
NOTICE
Data loss
All data on the HMI device is deleted during an update.
Back up your data before the restore operation, if necessary.
Requirements
● The HMI device is connected to a PC by means of the connection box and Ethernet.
● The ProSave application is installed on the PC.
● The ProSave add-on is installed on the PC.
● The data channel on the HMI device is configured.
Procedure
Proceed as follows:
1. Check that the HMI device is turned off.
2. Turn on the PC.
3. Start ProSave from the Windows Start menu on the PC.
4. Select the "Device type" "TP1000F Mobile RO" in the "General" tab.
5. Select "Ethernet" as the "Connection" between the HMI device and the PC.
6. Enter the IP address or the name of the HMI device.
7. Change to the "OS Update" tab.
8. Under "Opening", select the HMI device image file "*.fwf".
In the output area, you are provided information on the version of the HMI device image
file after it is opened.
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
Parameterizing the Mobile Panel
5.13 Functions for service and commissioning
125
Advertisement
Table of Contents
