Table of Contents
Advertisement
Installing system components
3.5 Connecting the Mobile Panel
3.5.4
Connecting PC and server
When you update the operating system on the HMI device or want to reset the HMI device to
factory settings, you have the transfer the image once again to the HMI device.
Procedure
1. Connect the PC to an Ethernet network.
2. Connect the HMI device to a connection box which is connected to the PC via the
Ethernet network.
3. Start to transfer the image using the ProSave software (see section "Updating the HMI
device image (ProSave) (Page 125)").
The figure below shows an example of how to connect the HMI device to a connection
box compact.
Connecting the server
Just as you would connect a PC, you can connect a Panel PC as server to the HMI device
as a server via the connection box.
46
Operating Instructions, 08/2017, A5E39831415-AA
TP1000F Mobile RO
Advertisement
Table of Contents
