Siemens SIMATIC HMI TP1000F Mobile RO Operating Instructions Manual page 93

Procedure
1. Open the "Screensaver" dialog using the "ScreenSaver" icon.
①
②
③
④
⑤
2. Enter the number of minutes after which the screen saver is to be activated.
The minimum setting is 1 minute and the maximum setting is 360 minutes. Entering "0"
disables the screen saver.
3. Select the type of screen saver:
– Use the "Standard" option to enable the default screensaver.
– Using the option "Standard with Dim Backlight" you activate the Windows standard
– Use the option "Blank Screen" to activate the disabling of the backlighting of the
4. Using the option "Dim Backlight to" you reduce the backlight to a value between 25% and
90%, without activating a screen saver.
If you enter a value outside the range of 25 to 90%, a message will appear and the value
is reset to 25%.
5. The "Allow manual dim up at deactivation of screensaver" for the "Blank Screen" screen
saver works as follows:
– If the option is activated, you can dim the display brightness on deactivation of the
– If the option is deactivated, the brightness is increased to the value that was set prior
6. If you want to delay touch operation for a brief time following deactivation of the "Blank
Screen" screensaver, for example, to prevent incorrect operator inputs in connection with
option
screensaver" check box.
7. Confirm your entries.
The dialog closes.
The screen saver for the HMI device has now been set. You will need to restart the HMI
device after the screen saver has been activated. The screen saver is then enabled.
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
Period of time in minutes before the screen saver is activated
Type of screen saver
Reduced backlighting to a specified value
Allow dimming when deactivating the "Blank Screen" screen saver
Short-term operation lock after deactivating the "Blank Screen" screen saver
screensaver and reduce the backlight to a value between 25% and 90%.
If you enter a value outside the range of 25 to 90%, a message will appear and the
value is reset to 25%.
device.
screen saver. The brightness is increased as long as you keep pressing the touch
screen.
to activation of the screen saver when you touch the touch screen.
④
, select the "Protect against operation within 500 ms after deactivation of
Parameterizing the Mobile Panel
5.7 General settings
93