Table of Contents
Advertisement
Installing system components
3.1
Checking the scope of delivery
Check the scope of delivery for visible signs of shipping damage and make sure that it is
complete, see section "Scope of delivery (Page 18)".
Note
Do not install parts damaged during shipment. In the case of damaged parts, contact your
Siemens representative. See section "Service and support (Page 184)".
3.2
Mounting the connection box compact
3.2.1
Mounting position, mounting cutout and clearance
Mounting position
The connection box is designed for installation in the following types of fixed enclosure:
● Mounting cabinets
● Control cabinets
● Control panels
● Consoles
The connection box compact can be installed in any mounting position.
Mounting cutout
The degree of protection is guaranteed if the following conditions are met:
Material thickness at the mounting
cutout
Deviation from plane at the mounting
cutout
Surface roughness in the area of the
mounting seal
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
2 to 6 mm
≤ 0.5 mm
This condition also applies for the installed connection box.
≤ 120 µm (R
120)
z
3
35
Advertisement
Table of Contents
