Remote Installation. Wall Mounting - Siemens MAG 1100 Operating Instructions Manual

SITRANS F M
6.2.3
Remote installation -
Wall mounting
(continued)
MAG 6000
Caution
Exposing the transmitter
to direct sunlight may
increase the operating
temperature above its
specified limit, and
decrease display visibilty
50
6. Installation of transmitter
Step 2
Take the SENSORPROM
the sensor. Mount the SENSORPROM
the wall mounting unit as shown. The text on the
®
SENSORPROM unit must face towards the
wall bracket.
Mount an earth wire between PE on connection
board and bottom of connection box.
Step 3
Mount the connection plate in the terminal box.
Fix the connection plate with the two diagonal
opposite screws.
Fit the coil , electrode , supply
B A
cables respectively and tighten the cable
D
glands to obtain optimum sealing. Please see
the wiring diagram in "Electrical connections"
Step 4
Mount the transmitter on the terminal box.
Attention
When remote mounted, power supply PE wire
must be connected to PE terminal.
Coil cable shield must be connected to SHIELD
terminal.
Use the supplied insulating tube to insulate the
core shield.
®
memory unit from
®
unit in
and output
C