Connecting The Ktp Mobile Connecting Cable To The Connection Box - Siemens SIMATIC HMI TP1000F Mobile RO Operating Instructions Manual

Table of Contents

Installing system components

3.7 Connecting the KTP Mobile connecting cable to the connection box

3.7

Connecting the KTP Mobile connecting cable to the connection box

The connecting cable can be connected to the connection box using a circular connector.

The connector is coded to prevent faulty insertion. The connecting cable is described in the

section "KTP Mobile connecting cable (Page 14)".

①

②

Procedure

Connecting

1. Align the positioning mark of the connector with the positioning mark on the socket of the

connection box.

2. Insert the connector into the socket of the connection box.

Additional characteristics of the Mobile Panel are described in the section "Testing Mobile

Panel readiness for operation (Page 70)".

The information in the section "Fail-safe operation (Page 149)" also applies to fail-safe

HMI devices.

Unplugging

1. Pull the outer bushing.

Do not tilt the connector when removing it.

2. If you do not intend to use the HMI device with a different connection box, place the HMI

device in its wall-mounting bracket.

Note

• Wait for about 1 second after you have unplugged the connecting cable from the

connection box before you plug in the connecting cable again.

• The socket of the connection box has IP65 degree of protection when the connecting

cable is plugged in or the cover cap in installed.