Siemens SIMATIC HMI TP1000F Mobile RO Operating Instructions Manual page 97

Procedure for setting the delay time
1. Select the desired delay time for the software start from the "Wait [sec]" selection box.
The delay time sets how long the Start Center is displayed before the
RemoteOperateClient software starts. Permissible values are 1, 3, 5 and 10 seconds.
– "0 seconds"
– "Forever"
Note
You can call the Start Center after starting the RemoteOperateClient software by closing
this software.
2. Confirm your entries with "OK".
The dialog closes.
Result
The delay time for the HMI device is now set.
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
The RemoteOperate software starts immediately. The Start Center is not displayed.
The RemoteOperate software is not started. The Start Center is displayed
permanently.
Parameterizing the Mobile Panel
5.7 General settings
97