Setting The Delay Time - Siemens SIMATIC HMI TP1000F Mobile RO Operating Instructions Manual

Parameterizing the Mobile Panel
5.7 General settings
5.7.6.2

Setting the delay time

Introduction
After switching on the HMI device, the RemoteOperate Client application starts after a delay
time.
Requirements
You have opened the "Directories" tab in the "Transfer Settings" dialog with the
"Transfer" icon.
①
②
③
④
Note
Settings under "Path"
Do not change the settings in the "Path" field. If changes are made here, the RemoteOperate
Client software may not start the next time the HMI device is switched on.
96
Location of the project file. Not relevant for the fail-safe HMI device.
Directory where the compressed source file of your project is saved
Not relevant for the fail-safe HMI device.
Location and start file for RemoteOperate Client
Selection box for the delay time
Operating Instructions, 08/2017, A5E39831415-AA
TP1000F Mobile RO