Table of Contents
Advertisement
3. Confirm your entries with "Save".
Note
For the "E-stop button evaluated by safety relay" operating mode:
• If password protection is already enabled, the password prompt is displayed.
• If no password has been assigned, you are prompted to assign a password.
Enter the password and confirm your entry.
You can find additional information on password protection in the section "Entering and
deleting a password (Page 90)".
The dialog closes. Information text
Connection Box"
4. Close the "Safety operation" dialog with "Close".
The operating mode is assigned.
See also
Using the HMI device in password-protected security mode (Page 75)
5.13
Functions for service and commissioning
5.13.1
Saving to external storage medium – backup
You can use this function to back up the operating system, applications and data from the
flash memory of the HMI device to an external storage medium.
Use a SIMATIC HMI Memory Card as the storage medium or an industrial USB flash drive.
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
Parameterizing the Mobile Panel
5.13 Functions for service and commissioning
④
shows: "Operation mode successfully stored in
117
Advertisement
Table of Contents
