Canon iR6570 Manual page 34

I Making the copy settings before selecting an output device:
If you set the copy mode before selecting a printing destination, only the remote copy printer supporting
the selected copy mode can be selected as the printing destination.
I Selecting the output device before selecting the copy settings:
To select a printing destination before setting a copy mode, only the copy mode supported by the
selected remote copy printer can be chosen.
1
IMPORTANT
• The Remote or Cascade Copy mode cannot be used with the Rotate Collate, Rotate Group, Saddle
Stitch, Shift (No. Key Entry), Divided Booklet, Transparency Interleaving, Mirror Image, Scan Image
Check, Interrupt Copy, or Sample Set modes.
• If you use Cover/Sheet Insertion with the remote or cascade copy mode, Auto Orientation is not
performed.
• The Remote Copy mode cannot be used with the Form Composition mode.
• If you use the Form Composition mode with the Cascade Copy mode, it is necessary to assign the
same name to the stored image form in both this machine and the remote copy printer beforehand. If
the assigned image form name in this machine is not set in the remote copy printer, the job is cancelled.
If multiple image forms with the same assigned name are stored in the remote copy printer, different
image may be used for Form Composition.
• If you power the remote copy printer back ON, you need to refresh the settings of the remote copy
printer from the Additional Functions screen. (See "Confirming a Remote Device," on p. 8-21.)
• If you connect the machine directly to other remote copy printers by crossover patch cord, you need to
configure the Ethernet driver as shown below. (See Chapter 2, "Settings Common to the Network
Protocols," in the Network Guide.)
- Auto Detect: Off
- Communication Mode: Full Duplex
- Ethernet Type: 100 Base-TX
1-20 Selecting an Output Device (Select Output Device)