Canon iR6570 Manual page 252

G If you want to add a cover page:
4
3
G If [Divided Booklet] is selected:
4-34 Booklet Mode
❑
Press [Add Cover] © [Next].
❑
Select whether to print on the cover page © press [Next].
❑
Select the desired paper type for the cover page © press [Next].
If the optional Saddle Finisher-T2 is not attached, press [OK].
IMPORTANT
• You must select the same paper size for the cover page as that used for the printing of the main
document.
• Only 64 to 200 g/m
2
paper can be used for the cover page.
• Only 64 to 90 g/m
2 paper can be used for the main document.
• If you select [Add Cover], you cannot specify the stack bypass as the paer source used for the
main document.
• When printing on special types of paper, such as heavy paper or transparencies, be sure to
correctly set the paper type, especially if you are using heavy paper. If the type of paper is not set
correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become
dirty, or the paper could jam, and a service repair may be needed.
NOTE
You must load the paper for the cover page face down in the stack bypass.
Select whether to saddle stitch the booklet © press [OK].
❑
Specify the number of sheets that you want to divide by using [-] and [+] © press [OK].
You can set the number of sheets to be divided from 1 to 15.
You can also enter values using
The selected mode is set.
NOTE
• If the number of sheets is 16 or more, the booklet cannot be saddle stitched.
• The number of saddle stitched booklets that booklet tray can hold depends on the number of
sheets that each booklet contains.
- 1 to 5 sheets: 25 sets
- 6 to 10 sheets: 15 sets
- 11 to 15 sheets: 10 sets
• Saddle Stitching is not performed if there is only one output sheet.
- (numeric keys).