Turning On The Detector - Thermo Scientific Vanquish VF-D20 Operating Manual

5.7

Turning On the Detector

Vanquish Charged Aerosol Detectors Operating Manual
TIP Before turning on the power to a Vanquish system module for the
first time, verify that the chromatography software is installed on the
data system computer. When the power is turned on, the required USB
drivers are automatically found and the Windows® operating system can
detect the device.
To turn on the power to the detector, follow these steps:
1. Check that the power button on the front left of the Vanquish
system base (system power button) is pressed in. If the power
button stands out, press the power button to turn on the power on
the system base.
2. Turn on the detector with its main power switch.
Turn the detector off with the main power switch, when instructed to do
so, for example, during maintenance. Pressing the system power button
will not be sufficient to turn off the power to the device completely.
For power on/off control during detector operation, see
page 91.
NOTICE Make sure that the pump flow to the detector is turned off. To
properly turn on the detector gas flow and only then turn on the pump
flow to the detector, follow the instructions in
Detector for Operation, page
section 6.5 Preparing the
92.
5 • Installation
section 6.4,
Page 81