Thermo Scientific Vanquish VF-D20 Operating Manual page 149

Vanquish Charged Aerosol Detectors Operating Manual
d) Push the slide-in module onto the rails and into the enclosure
until the slide-in module sits completely in the enclosure.
Figure 40: Inserting the slide-in module
4. Tighten the four captive screws on the slide-in module hand-tight.
NOTICE Verify that the screws are tightened. Pull the slide-in module
by the leak tray towards the front and check whether the screws
move. If they do not move, the slide-in module is installed properly.
If the screws move, tighten the screws further.
5. Set up the slide-in module:
a) To connect the slide-in module and to set up flow connections,
follow the instructions in the Installation chapter in this
operating manual.
b) To prepare the slide-in module for first-time operation, follow
the instructions in the Preparing the Detector for Operation
section in this operating manual.
6. Prepare all other modules of the Vanquish system for operation and
restart them. Refer to the Operating Manuals for the modules.
7. Before starting an analysis, let the chromatography system
equilibrate and be sure that it is ready for operation.
7 • Maintenance and Service
Page 149